MyTek Stereo 192 ADC User Manual download pdf (Page 36)

Mytek Stereo 192-DSD Digital to Analog Converter – User Manual

Internal User Adjustments

Inside the unit you will find the 115/230 voltage switch.

Normally this will be set to the proper voltage for the country

of destination. If you need to switch the voltage, it can be

found between the power plug socket and the toroidal

transformer. The voltage value is printed next to the switch.

*For Japanese models only: 115V = 100V, 230V = 230V

There are also jumpers that allow you to bypass the capacitors

in the analog input signal path. This will extend the low-

frequency response to 0 Hz. It will also allow DC to pass, so

only bypass the capacitors if you are sure that there is no DC in

your signal, as DC can be harmful. The jumpers are located

behind the output XLR's.

Internal -6db Gain Jumpers

These 4 jumpers allow the user to lower the

output level of the DAC by -6 db without

affecting sound quality. All 4 jumpers must be

engaged to ensure proper operation and should

only be used when the DAC is clearly

overloading the following amplifier stage in the

chain.

www.mytekdigital.com Page: 36/47

XLR R XLR L

XLR R XLR LXLR R XLR L

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 46 47

No comments

MyTek Stereo 192 ADC User Manual Page 36